Original Airbot F7 Flight Controller AIO Betaflight OSD 5V BEC 3-6S for RC Drone FPV Racing
A part of the review has been auto-translated.
F7 Multi-Function Thin Board No projections on the back On the surface side, the ESC connectors and BEC components are the highest, and the board is only about 4.65mm thick Our thin ESC was about 4.2mm, so you can use two layers at less than 10mm (^-^) The extra space allows you to layer any board you like, whether it's a VTX or an LED controller (^-^) I prefer thin airframes (looks like (laughs)), so if there's space around the stack, I'm packing RX, TBS VTX, etc., to shorten the standoff and lower the upper deck When the battery is mounted on the upper side, it can contribute to mass concentration (^-^) Even a beginner, I can see the difference when I try to build up and down on this aircraft The company's ESC has no projections on the back, and the highest is the connector, and even if the FC is mounted on the ESC connector, the cable can be used between the FC and the ESC to access the solder pad (^-^) I hope this will have the barometer attached (^-^)
perfect quality .. and as always very fast delivery