Out of the box faults: - RX antenna which should be a TX (it is a video transmitter BG!0 - Crack under the canopy mounting hole After removing the push rods for alignment the arms are moving heavily which is not normal if they run into bearings. The probem: - Clamp bold head are to wide, the clamp is 4mm the bolt head is 4.5 so it touches the outside of the bearing. - Clamp is touching the the bearing because it is missing a spacer. So fixing the bold is not a option, a different clamp or just adding a spacer will solve this ! SBUS conversion: If you use the Frsky SBUS the PWM outputs are still working, so I use a SBUS converted X4R receiver (adding a resistor gives you SBUS on output 4 (google for it). So you use SBUS and PPM together only using a 4Ch (3pwm) receiver. For SBUS connection solder a servo cable on AUX3 on the FC, see picture and set SBUS in Cleanfilght. Working great!! Locktite the canopy holders !! because the first flight they where all over the place/ //Frank

Out of the box faults: - RX antenna which should be a TX (it is a video transmitter BG!0 - Crack under the canopy mounting hole After removing the push rods for alignment the arms are moving heavily which is not normal if they run into bearings. The probem: - Clamp bold head are to wide, the clamp is 4mm the bolt head is 4.5 so it touches the outside of the bearing. - Clamp is touching the the bearing because it is missing a spacer. So fixing the bold is not a option, a different clamp or just adding a spacer will solve this ! SBUS conversion: If you use the Frsky SBUS the PWM outputs are still working, so I use a SBUS converted X4R receiver (adding a resistor gives you SBUS on output 4 (google for it). So you use SBUS and PPM together only using a 4Ch (3pwm) receiver. For SBUS connection solder a servo cable on AUX3 on the FC, see picture and set SBUS in Cleanfilght. Working great!! Locktite the canopy holders !! because the first flight they where all over the place/ //Frank

Out of the box faults: - RX antenna which should be a TX (it is a video transmitter BG!0 - Crack under the canopy mounting hole After removing the push rods for alignment the arms are moving heavily which is not normal if they run into bearings. The probem: - Clamp bold head are to wide, the clamp is 4mm the bolt head is 4.5 so it touches the outside of the bearing. - Clamp is touching the the bearing because it is missing a spacer. So fixing the bold is not a option, a different clamp or just adding a spacer will solve this ! SBUS conversion: If you use the Frsky SBUS the PWM outputs are still working, so I use a SBUS converted X4R receiver (adding a resistor gives you SBUS on output 4 (google for it). So you use SBUS and PPM together only using a 4Ch (3pwm) receiver. For SBUS connection solder a servo cable on AUX3 on the FC, see picture and set SBUS in Cleanfilght. Working great!! Locktite the canopy holders !! because the first flight they where all over the place/ //Frank

Very good drone! Your concept is very nice. This drone has a brutal fpv driving. The camera angle is always the same. Try it !!

Very good drone! Your concept is very nice. This drone has a brutal fpv driving. The camera angle is always the same. Try it !!

Very good drone! Your concept is very nice. This drone has a brutal fpv driving. The camera angle is always the same. Try it !!