New customer? Start here.
My Account My Orders My Wishlist My Coupons My Points My Referrals BGpaysonny Hi Binco,I have ordered the same,is the motor easy to fit?
Reply 15/05/2020Binco94 Hi Sonny, sorry for my late response...the motor mount is a standard cross, quote difficult to reach but not impossible with a good long screwdriver...i used a D3536-750kv motor from h.king and fit perfectly
Reply 25/05/2020Binco94 @sonny Another advise that i would liketo give is this one...if you plan to use the big original spinner, connect the lower air intake on the front to allow motor cooling...the two tunnels are not connected and during some motor test i noticed that after a short while the motor was quite hot due to lack of moving air caused by the big spinner...so i made a hole to connect the lower cooling tunnel with the engine housing adn i used a small plastic sheet to direct the coming air on the upper section, where the motor mount is...this improved cooling a lot and i've no fear on run this setup in 4s...hope will be usefull!
Reply 26/05/2020brian ARE THE RETRACT INC IN THE KIT MODEL ?
Reply 23/10/2020brian WHAT MOTOR DID YOU USE FOR THE KIT VERISON ? THANK'S
Reply 24/10/2020brian HI WHERE THE ALIERON SERVOE'S FITTED ?
Reply 25/10/2020Binco94 yes, retract are included and already installed on kit version...check my previous comment for motor specs...ailerons servos are on the lower center part of the wing, just before aileron "inner" edge of the aileron...
Reply 29/10/2020Our Company | Contact Us | Payment & Shipping | Partnership Programs |
---|---|---|---|