Banggood Dear customer,we apologize for any inconvenience to you,about your product problem, our customer service have contacted you, we would give you a solution in time.

Submit

Turkish Flyer ' sir palle ' - Calibration and programming of the ESC is as follows: (1) - put the throttle stick and trim on your transmitter ( TX ) to full up ( maximum throttle ); (2) - turn on TX; (3) - power-up your receiver ( RX ) with motor connected to RX channel-3 WITHOUT a propeller; (4) - wait for ESC to beep and cycle through beep sequence; (5) - put throttle stick and trim all the way down ( minimum ); (6) - disconnect RX from power; (7) - turn off TX.

Submit

Turkish Flyer Please note that for proper ESC operation, the calibration and programming of the ESC is as follows: (1) - put the throttle stick and trim on your transmitter ( TX ) to full up ( maximum throttle ); (2) - turn on TX; (3) - power-up your receiver ( RX ) with motor connected to RX channel-3 WITHOUT a propeller; (4) - wait for ESC to beep and cycle through beep sequence; (5) - put throttle stick and trim all the way down ( minimum ); (6) - disconnect RX from power; (7) - turn off TX.

Submit

magne My motors wont run properly. And they just keep beeping. Do i have to programm each esc for themself? Or connect all and then do the calibration? These esc are going on my nerves.... What the hell made you sell these things as quadcopter partsjQuery191031116006313823164_1445162757311 Not suited at all!

Submit

banggood @magne Dear customer,we are sorry to hear that,please contact cservice@banggood.com for help,thanks!

Submit