YA-HW05 433mhz Auto Wireless PIR Sensor Detector for GSM Home Security Burglar System Reviews

YA-HW05 433mhz Auto Wireless PIR Sensor Detector for GSM Home Security Burglar System

8,29€
~~9,95€~~
Buy now

Customer Reviews

5 out of 5

See all 11 reviews

5 star
11 (100.0%)
4 star
0 (0%)
3 star
0 (0%)
2 star
0 (0%)
1 star
0 (0%)

Write a Review Get double review points if you are one of the first 3 reviews published!

All Reviews (11)
Image (1)
Video (0)
All Star
- All Star(11)
- 5 Star(11)
- 4 Star(0)
- 3 Star(0)
- 2 Star(0)
- 1 Star(0)

Sort by:

Top Review

Top Review
Most Helpful
Most Recent

Reviews only from your country (Philippines)

Show Original

A part of the review has been auto-translated.

urosfriVIP3
SI
19/09/2016

I just recieve this sensor. It is working very good with this set: http://www.banggood.com/433MHz-Wireless-GSM-Alarm-System-for-Home-Security-System-with-PIRDoor-Sensor-85090018001900MHz-Quad-Band-p-1020196.html

I just recieve this sensor. It is working very good with this set: http://www.banggood.com/433MHz-Wireless-GSM-Alarm-System-for-Home-Security-System-with-PIRDoor-Sensor-85090018001900MHz-Quad-Band-p-1020196.html

I just recieve this sensor. It is working very good with this set: http://www.banggood.com/433MHz-Wireless-GSM-Alarm-System-for-Home-Security-System-with-PIRDoor-Sensor-85090018001900MHz-Quad-Band-p-1020196.html
0

Comments

Show Original
feiticeir0VIP4
PT
22/01/2020

It works well - or so I tough - with the Sonoff RF Bridge . At first it was perfect. Detecting every move and sending the RF code to the Sonoff bridge and my home Assistant turning the lamp on. After a few times, the Sonoff bridge stopped receiving the RF signal... The PIR detects the person, but no code is sent... It's new, the battery sure is fully charged. When to check the battery with a multimeter, and battery is full... Haven't tried with a new battery, but since this one is full, no need to . I don't recommend it

It works well - or so I tough - with the Sonoff RF Bridge . At first it was perfect. Detecting every move and sending the RF code to the Sonoff bridge and my home Assistant turning the lamp on. After a few times, the Sonoff bridge stopped receiving the RF signal... The PIR detects the person, but no code is sent... It's new, the battery sure is fully charged. When to check the battery with a multimeter, and battery is full... Haven't tried with a new battery, but since this one is full, no need to . I don't recommend it

It works well - or so I tough - with the Sonoff RF Bridge . At first it was perfect. Detecting every move and sending the RF code to the Sonoff bridge and my home Assistant turning the lamp on. After a few times, the Sonoff bridge stopped receiving the RF signal... The PIR detects the person, but no code is sent... It's new, the battery sure is fully charged. When to check the battery with a multimeter, and battery is full... Haven't tried with a new battery, but since this one is full, no need to . I don't recommend it
0

Comments

Show Original