Ianlaing1
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: well this work with happy model elrs receivers too, or just yours?
Asked by Scotty2Quady on 2021-07-17 09:16:40
Q: Will this work with x8r receiver?
Asked by Colin Doughty on 2021-06-19 16:02:35
Ianlaing1 no
Helpful (0)
Q: is it suitable with Jumper t-lite transmitter?
Asked by KarloBalboa on 2021-04-19 14:37:48
Ianlaing1 if you have a 3d printer then no
Helpful (0)
Ian The Post for the tx805 json from github will work at rated power the TX805S.. ignor the fact it say 800, its actually providing the full at 1.6w at the 4th power setting...
Helpful (0)
Q: do you have a direct drive version (not Bowden Long range but direct drive for bondtech prusa setup)
Asked by Paul Cole on 2019-03-27 20:40:45
Ian depending on setup with work with say a titan extruder which uses a short PTFE tube ..
Helpful (0)
Q: where can I plug SUMD (graupner sbus) ?
Asked by aircraftfire07 on 2019-03-06 15:49:56
BG451864550 rx3
Helpful (0)
Q: will this work on normal r9m? like r9mm normal does?
Asked by FTJ on 2019-09-28 11:03:36
ian.laing I was not able to use this receiver with the non access R9M module :( rather buy non access receivers for older modules.. Maybe someone else has managed to use this receiver in with r9m TX..?
Helpful (0)
Q: Can't seem to find a termination plug that fits. Could you link one?
Asked by rippst on 2018-11-30 04:56:44
ian.laing there appears to be no dummy 50 ohm available for these. Makes them useless. Rather buy the other antenna that have male not female like these...
Helpful (0)
Ianlaing1 will work with any expresslrs flashed hardware.
Helpful (1)