micro
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: Hello, can I install this board to AWD MA-010?
Asked by Sloper on 2020-10-11 04:00:42
Q: Hi! Supports frsky r9m module? And will rrsi be displayed on the screen?
Asked by AlexResh on 2018-08-30 03:46:54
micro r9m is 900mhz, Jumper is 2.4mhz only so cannot support it even if protocol is made open
Helpful (0)
micro These are for the main shaft top and bottom. They are not for the head, you need smaller version for blade grips.
Helpful (0)
Q: Now that T12 JumperTX firmware is a fork off OTX, where can source/updates be found?
Asked by GZGZGZ on 2018-08-26 16:12:12
micro It uses Q7 firmware so I think it is safe to assume we get all updates.
Helpful (0)
Q: can this bind with XK K110, V988 and V911?
Asked by Jack on 2018-08-21 01:32:42
micro Yes, tested fully with K110. https://www.youtube.com/watch?v=wdkIrHOERK8&lc=UgyLy2IKYgf_sDAqO_p4AaABAg&ab_channel=MicroRCFiend
Helpful (0)
micro I think it does not have throttle ratchet. Any tx with it just requires adjustment of one screw inside to lift the ratchet spring enough to not make contact.
Helpful (0)
Q: Because it doesn't come with a programming cable, what to do?
Asked by jax200 on 2018-02-09 10:05:08
micro Bunch of option to control it, al mentioned here and another in the comments below. https://www.youtube.com/watch?v=nd3mxqAuMMk&t=3s&ab_channel=MicroRCFiend
Helpful (0)
micro You can solder resistors to the servo wires before the board to increase steering angle. I did it on old MR03 board fitted to AWD chassis to fix the steering angle issue. 1.8k resistors on the 3v and GND line was perfect for me. Leave the 'pot' wire without resistor. I have pics I can't add here but hit me up on YT if you need em. microrcfiend
Helpful (1)