Marco_666
Q: How many bits is the laser engraver firmware?
Asked by Pedro Costa on 2021-02-14 05:26:58
Marco_666 Non saprei darti una risposta corretta
2022-12-02 06:26:12 Helpful (0)
Marco_666 In 1 passaggio nessuno In 4 passaggi con air assist su 3mm hai un lavoro preciso. Tieni conto che x il taglio io uso il metodo “veloce e forte” Velocità alta ma alta la potenza. E ci fai un passaggio in più Ovviamente con air assist
2022-12-02 06:25:35 Helpful (0)
Marco_666 Se le linee non escono dritte devi tirare le cinghie degli assi corrispondenti È solo da regolare
2022-12-02 06:22:07 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
