javitoi
Q: hi, is this the global version? thank you.
Asked by javiernovellparma on 2017-11-03 10:51:43
Q: to vbat i have to connect the battery directly to VCC and Curr?
Asked by javitoi on 2019-02-16 11:27:29
lacvo This Matek FC board usually requires a PDB (power distribution board). To supply power to this FC, you need to connect power (Vbat and GND) to the pins on this board. In case you use a 4in1 ESC, then the connector between 4in1 ECC and this FC provide the power needed. Check mateksys.com for wiring references
2021-01-11 08:43:13 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
LucasAlmeidaSantos Sim , essa é a versão global.
2022-07-14 08:11:56 Helpful (0)