Contagioussmile
Q: do I need to install the firmware again or is it installed?
Asked by Contagioussmile on 2019-04-02 01:16:31
Gangar9Zweet installed already
2019-04-07 05:48:42 Helpful (0)
Q: can we use a 3mm filament witb this extruder??
Asked by Contagioussmile on 2018-07-03 01:55:40
Steatogenous 1.75mm is best.
2018-07-12 03:12:12 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
