All Messages

Q: Hi is it with phone holder

Asked by BG158472510 on 2023-06-09 06:47:53

schnuepp2 no, there is no phone holder included. However you might fine some phone calmping-device that can be fixed to the handlebar on top of the TX.

2023-06-10 03:59:03 Helpful (0)
Submit
Answers (3)

schnuepp2 I do not know your boat, but the dimensions of this battery are 45 x 96 x 20 mm (not including the cables). The weight is 166 g

2022-05-10 04:25:25 Helpful (0)
Submit
Answers (1)

Q: will this work for hv lipo ?

Asked by Francis Brunette on 2021-12-18 03:50:18

schnuepp2 Yes, this cell meter can handle LIPOs from 1S to 8S (one to eight cells).

2021-12-18 04:27:52 Helpful (0)
Submit
Answers (4)

Q: what are the dimensions of the board please.

Asked by ipbladerunner on 2021-10-25 03:25:17

schnuepp2 24,5 mm width x 28 mm length x 17 mm height

2021-10-26 01:22:23 Helpful (0)
Submit
Answers (2)

schnuepp2 I had also seen both versions in presentations on the Internet. I had bought the kit with the included motor and decided on the internal mount of the motor. This solution looks much better and provides a better protection for the motor. The motor cooling is still sufficient with the internal installation. With this glider you will not run the motor at full speed all the time. Besides, the mounting in front of the fuselage would have required a disassembly of the motor rotor an stator, since with the motor provided in this kit, the motor shaft was fixed to the stator. With the internal mounting the motor housing (stator with the magnets) rotates inside the fuselage, whilst the rotor with the electromagnets is stationary.

2021-09-20 01:52:42 Helpful (0)
Submit
Answers (1)

Q: Can I bind it with a spectrum dx5e controller??

Asked by BG523317424 on 2021-08-14 12:10:45

schnuepp2 no spectrum uses a different protocol. This receiver can be bound to FlySky controllers with AFHDS protocol.

2021-08-16 07:38:47 Helpful (0)
Submit
Answers (7)