Neslarc
Zeemax It will buzz constantly until you disconnect it
2020-10-20 09:41:23 Helpful (1)
Neslarc The probe wires to the circuit board keep breaking off. I solder them back on but after a short while they break again.
Q: All my Rx are Flysky. What module do you need to add FlySky AFHDS and AFHDS2A to the TX18S/Lite?
Asked by Neslarc on 2020-09-18 06:26:08
machead Just buy the full version for USD20 extra. The A7105 module alone cost USD14. Saves you the hassle of hacking the transmitter and guaranteed to work.
2020-09-18 06:44:10 Helpful (1)
Q: What i sthe max voltage and current for this motor?? I think i over powered them
Asked by Tsar Rex on 2019-10-03 10:08:27
Neslarc They are for 3.7V 1S lipo battery brushed ESC. I wouldn't exceed 5V. Don't know what the amp load is but it is very low. You can get 20 minutes flying on a 250 mAh 1S battery.
2019-10-04 06:10:48 Helpful (2)Q: can I use this prop for motor mounted on the back of the plane?
Asked by RONAK10 on 2018-02-27 03:01:24
Neslarc Yes. Always mount the propeller so the numbers on the blades face towards the front of the airplane. You will have to reverse the direction of the motor rotation.
2019-08-11 08:31:17 Helpful (0)Q: With which protocol it's works?
Asked by racz96 on 2019-06-13 04:01:44
Neslarc It uses Flysky AFHDS protocol.
2019-07-10 07:19:24 Helpful (0)Q: is it compatible with the flysky fs-I6?
Asked by Adryanvdb on 2018-10-18 11:49:02
Neslarc Yes. It binds to Flysky FS-i6 transmitter if you switch to AFHDS protocol. You have to bind to the transmitter every time you change the battery.
2019-07-10 07:17:53 Helpful (0)Q: What is the motor shaft diameter?
Asked by Neslarc on 2019-02-08 07:24:43
Jonnie 3.17mm
2019-02-27 08:15:40 Helpful (2)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
BG723215041Kel55 You unplug it so then you replug it in . Then you can see the display tells you the current Voltage
2022-02-04 10:47:09 Helpful (1)