Danny
Danny Stepper Motor Encoder cable is too short for the Z axis.
Q: is encoder inside in stepper?
Asked by BOSTJAN GABROVSEK on 2021-02-03 12:03:19
Danny Yes, the encoder is on back of motor
2021-02-06 08:01:51 Helpful (0)Q: Does the controller input DC as well as AC, is there the option of inputing DC?
Asked by dan on 2020-04-02 04:17:35
Danny Yes, If you have DC, attach - and + to AC terminals in any order
2021-01-29 10:26:27 Helpful (0)
Danny Yes there is shielding. Don't know if the shield is grounded on motor end but assume so
2021-01-29 10:23:45 Helpful (0)
Danny Stepping angle is selectable with dip switches
2021-01-29 10:21:43 Helpful (0)
Danny Shaft is 14 mm
2021-01-27 04:12:37 Helpful (0)
Danny Shaft is 14mm
2021-01-27 04:10:48 Helpful (2)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
