clue_to_everything
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: Can I use this gimbal with MJX Bugs 4W 4K ? Will my drone be able to lifted?
Asked by NR2010 on 2021-12-30 08:00:01
Q: How many volts minimum and maximum?
Asked by m1s on 2020-02-02 00:26:09
clue_to_everything it starts working at 11.5v at 9v only led will light up but motors won't move at 12v it's the best , max I haven't tested
Helpful (0)
Q: what is a good power supply for this?
Asked by BG103254534 on 2020-09-23 03:35:15
clue_to_everything Use A 12V 10 Amp SMPS , Make Sure The SMPS has fuse for safety
Helpful (0)
Q: can I use a 4s battery? I don't have a 3s
Asked by ItoSan on 2019-02-06 14:59:13
clue_to_everything NO, 4s voltage is very high , however please refer to your flight controller data sheet and check does it have pins for bgc or gimbals , or try to figure out if you can get voltage anywhere between 10-12 volts from your flight controller
Helpful (0)
Q: Will this work with an SJCAM SJ4000 camera?
Asked by BG349326121 on 2020-11-09 19:22:48
clue_to_everything itshould
Helpful (0)
clue_to_everything onlyGimbal is provided , Camera is not included
Helpful (0)
clue_to_everything onlyGimbal is provided , Camera is not included
Helpful (0)Q: How do I control the motors with Arduino? Do I need ESC? Or I can directly control through Arduino?
Asked by chen740909527 on 2019-07-10 15:16:30
BG127145371 yes connect the control pin to digital pin on arduino and control it with PWM
Helpful (0)
clue_to_everything check the Thrust produced it should be twice the weight of drone, if it's producing then it can lift else no
Helpful (0)