guglielmon R-XRS

simole88 Hi, if you use a 3S lipo and 20A ESC, I suggest to work with 8-10 inch prop. If you use the recommended electronic, the MM2212 1100KV motor supports the following propeller: 8x4.3, 9x4.7 and 10x4.7. ... Hi, if you use a 3S lipo and 20A ESC, I suggest to work with 8-10 inch prop. If you use the recommended electronic, the MM2212 1100KV motor supports the following propeller: 8x4.3, 9x4.7 and 10x4.7. I do not recommend the 10x4" prop because it is excessive and requires too much power (@ 12.6 V > 17.5A > 220W > and a thrust of 750g). This foldable propeller of ASW28 is not recommended because it is a 10x6" prop.. See More

schnuepp2 I had also seen both versions in presentations on the Internet. I had bought the kit with the included motor and decided on the internal mount of the motor. This solution looks much better and provide... I had also seen both versions in presentations on the Internet. I had bought the kit with the included motor and decided on the internal mount of the motor. This solution looks much better and provides a better protection for the motor. The motor cooling is still sufficient with the internal installation. With this glider you will not run the motor at full speed all the time. Besides, the mounting in front of the fuselage would have required a disassembly of the motor rotor an stator, since with the motor provided in this kit, the motor shaft was fixed to the stator. With the internal mounting the motor housing (stator with the magnets) rotates inside the fuselage, whilst the rotor with the electromagnets is stationary. See More

Kahunarant7541 yes

Scottyog Yes it does work yes